Setup router as a switch

Each port on the switch is a different IP address. Probably not unless your modem integrates the function of a router so that you can rewire and reconfigure the wireless router to set it up as access point. Seen from the outside, you indeed put a managed switch before router, however it still follows the principle that router goes before network switch. Network switch before router or after router? Have you made it clear?

This post has stated modem to router to switch vs modem to switch to router. Hope when you set up your network with router and switch, you can put them in the correct order according to your needs and the products themselves the modem type.

Here at FS. While switches allow different devices on one network to communicate, routers allow different networks to communicate. Actually, a switch creates networks while a router connects networks. In addition, a router uses IP address for data transmission, while a network switch uses the MAC address. However, when the number of devices is over 4, a network switch is necessary.

You can use the network switch to expend your wired network with more ports. There are various switches of different port counts such as 8-port, port, port switch available in the market.

Step 1: Unplug all the power supplies of cable modem, network switch and wireless router. Step 2: Connect your modem to the telephone wire. Save the setting, and update your local machine configuration to have an IP in the Now you can actually bridge the ports. For that, you need to execute the following commands to add the range of ports on the switch chip to the switch collection:.

Notice that because we are putting the router on the same subnet as the USG, we need to make sure that the IPs are in the Because the USG will use My set-up consisted of several components, laid out as such: Now you might be asking - why do I have two routers in the pipeline? Given the background, here are the steps taken to make it happen: Reset the EdgeRouter to factory settings. That way you can get a clean configuration slate.

You can do so by unplugging the power cord, holding the reset button and plugging the power cord back. Many thanks in advance,. Posts: Options Report Inappropriate Content. Guest network stopped working afterwards. The good part, I was pleasantly surprised how easy it was to set up. The sad part is that Guest network stopped working. I can see it in the list of networks, but when I try to connect, it goes forever "obtaining IP address" or "identifying" in Windows.